There is an STC for these but it has long since become a floating STC. I installed these as a minor alteration but used the STC as my data for installation. It is a pretty simple sheet metal project but you have to be careful. I do have these louvers coming available soon as a owner produced part.
We used a English Wheel to make this cowl for this Taylorcraft that was once owned by Ramblin’ Rod. Ramblin’ Rod had a children’s show in the 1960’s which kids would go to, sit on the bleachers and watch which I was one of. Using an English wheel is a lot of fun but takes…
After removing the tail we found that an earlier replacement of the tail bulkheads with a later model 180 bulkhead, probably because of the plane going over on its back, was not done very well…….
When repairing a cowl I try to balance the repairs out and it is important to make the repairs look as if it is part of the original cowl or nice enough to make the cowl look better if not stronger and most important last. One thing is these cowl repairs are time consuming and…
B19 same as B23Sheet metal work is as much an art as a skill. Most of the time there is very little to guide you other than a picture, some references in the maintenance manual or parts manual. And of corse the AC 43.13 to reference to. What also counts I’d how the repair or…
When repairing a cowl I try to balance the repairs out and it is important to make the repairs look as if it is part of the original cowl or nice enough to make the cowl look better if not stronger and most important last. One thing is these cowl repairs are time consuming and…
Just was out replacing a spar carry through on a Cessna 182, the problem was found during an annual inspection the culprit was an interior headliner that was glued to the spar carry through and moisture was caught between the fabric and the spar. This was the first annual for my customer on this plane,…