B19 same as B23
Sheet metal work is as much an art as a skill. Most of the time there is very little to guide you other than a picture, some references in the maintenance manual or parts manual. And of corse the AC 43.13 to reference to. What also counts I’d how the repair or modificaton looks, in my world it need to look as if the factory did the work.
After removing the tail we found that an earlier replacement of the tail bulkheads with a later model 180 bulkhead, probably because of the plane going over on its back, was not done very well…….
These door I modified using a Beech Sundowner door latch, works really well and it is new. After 60 years of opening and closing those old latches just wear out and there seems to be no good option. New parts are hard to find and old used parts are just that. This is a good…
Replaced both left and right horizontal tips with Mc Farlane tips using 8 32 screws in place of rivets. The idea is that you can easily change out the tip if damaged, one thing is that if you operate a seaplane you need to put some corrosion protection on the nut plates and screws on…
This is a 12000 hour Cessna 182, the cracks are found in the corner of the web, hard to see. Once the crack was found the aircraft was grounded, no ferry permit allowed. We spent three long days and travel to get the job done
It all starts with rivets and time.
